Part Number: 224578

PRODUCT DESCRIPTION:

This is ProSpeed's standard light bar mount, it cannot be fitted alongside the Land Rover raised air intake however it is compatible with the Safari snorkel.

• Tubular protection light mounting bar for the Land Rover Discovery 3 and 4.
• Mounts into existing holes on the A-pillar under the plastic trim. Two holes require enlarging by approx. 1mm.
• Adjustable tilt angle.
• Optimum mounting position just above the top of the windscreen
• Designed to fit Lazer Lamps (road legal solution) but has a number of pre-drilled holes to work with any light setup.
• Mounted as close to the roof line ass possible for reduced wind noise.
• It doesn’t increase the height of the vehicle above the standard or extended roof rails.
• Compatible with or without the ProSpeed roof rack.

WIRING LOOM:

• Plug and play – direct into the standard Land Rover lighting stalk plug. No splicing looms, no scotch locks. No tools required.
• Shaped to exactly fit the Discovery 3 and 4.
• Routed so there’s no need to drill any holes or cut out any plastic or panels.
• Fits LHD and RHD vehicles.
• 100% waterproof.
• Abrasion resistant covering where required.
• Thin ribbon loom down a-pillar to prevent the trim popping off.
• Takes power direct from the battery.

AUXILIARY CONTROL MODE:

• Entirely solid state – no relays nor moving parts to wear out or go wrong.
• Self resetting fuses – all the protection with none of the hassle. If there’s a problem, the fuses will blow to protect the circuit. But when the problem is fixed the circuit will re-connect automatically.
• 100% waterproof.
• Compatible with LED, HID and normal lamps.
• Switching is compatible with normal 12v vehicle systems and also CN bus systems including diagnostic circuits and power-saving circuits. This massively simplifies wiring in a modern vehicle where CAN bus systems have both power saving and diagnostic pulses which make it impossible to wire auxiliary lamps to them.
• Completely isolated from the CAN bus circuits , meaning no damage or faults can occur in expensive body control modules of modern cars.
• Runs 4x roof lamps on two circuits , 2x bumper lamps and DRLs, 4x work lamps on two separate circuits.
• Switching for forward facing lamps is – Off, On with main beam, On permanently

Specific ProSpeed accessories, Here!

DIFFERENT SET UPS:

1. ProSpeed light bar mount only – 240€
2. ProSpeed light bar mount with two Lazer ST-8 or Triple-R 1000 LED spotlights (includes wiring loom and control module) – 1750€
   
3. ProSpeed light bar mount with four Lazer ST-4 or Triple-R 750 LED Spotlights (includes wiring loom and control module) – 1950€
4. ProSpeed light bar mount with two Lazer ST-8 or Triple-R 1000 and two Lazer ST-4 or Triple-R 750 LED Spotlights (includes wiring loom and control module) – 2300€
   

Every set-up we offer is road legal using Lazer’s E11 approved driving beams. Please state which lights you’d like when ordering.

For delivery information, please click Here!